Another piece of the puzzle to think about. When trying to connect to a Service Center my FW-1 log shows the following message:
message_info: Implied rule encryption failure: Different community ID, possible NAT problem (VPN Error code 02) Steve -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Ray Sent: Wednesday, February 16, 2005 10:12 AM To: [email protected] Subject: Re: [FW-1] VPN-1 Edge X Setup Check out 5.0.50. It fixed a bunch of VPN problems in 5.0.43 including a memory leak that made me have to reboot mine every few days. Ray >From: Russell Aspinwall <[EMAIL PROTECTED]> >Reply-To: Mailing list for discussion of Firewall-1 ><[email protected]> >To: [email protected] >Subject: Re: [FW-1] VPN-1 Edge X Setup >Date: Wed, 16 Feb 2005 14:15:15 +0000 > >Hi, > >I have used a variety of firmware versions on the Edge and found >v5.0.43x a vast improvement since v4.0.93x and many in between. Site to >Site VPNs offer a significantly better level of performance and >reliability, primarily NGAI R55 to Edge, Edge to Edge VPNs have not >been a problem. > >Stephen W. Stewart wrote: >>Hi All, >> >>Trying to set up an Edge X box for a remote office in Site to Site mode. >>I currently have 2 other sites that are working just fine. The only >>difference with the new X is that it will have a static IP and the two >>that are working are using DHCP. >> >>I can create the site and then look in the reports section at the VPN >>Tunnels section and nothing shows up. If I ping the internal IP of >>the X box a tunnel is established and the X box replies. I cannot >>ping the other way into the "home" network behind the FW-1. >> >>The established tunnel shows IKE (Phase 1): 3DES/SHA1. >> >>Any ideas? >> >>Thanks >> >> >>Stephen W. Stewart >> >>================================================= >>To set vacation, Out-Of-Office, or away messages, send an email to >>[EMAIL PROTECTED] >>in the BODY of the email add: >>set fw-1-mailinglist nomail >>================================================= >>To unsubscribe from this mailing list, please see the instructions at >>http://www.checkpoint.com/services/mailing.html >>================================================= >>If you have any questions on how to change your subscription options, >>email [EMAIL PROTECTED] >>================================================= >> > > >-- >Regards > >Russell > >================================================= >To set vacation, Out-Of-Office, or away messages, send an email to >[EMAIL PROTECTED] >in the BODY of the email add: >set fw-1-mailinglist nomail >================================================= >To unsubscribe from this mailing list, >please see the instructions at >http://www.checkpoint.com/services/mailing.html >================================================= >If you have any questions on how to change your subscription options, >email [EMAIL PROTECTED] >================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
