You could use IP Pools perhaps, where you configure a network for the users to grab an IP address when they authenticate. Then add routes to route that specific network out through the Firewalls interface.
Cheers. -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Timothy Arnold Sent: Wednesday, April 20, 2005 9:39 AM To: [email protected] Subject: [FW-1] VPN Advice Hi, (Running Nokia IP350 cluster with R56) I am fairly new to Checkpoint/Nokia and I am currently looking for some VPN advice. I have configured the securemote client to access the VPN across the Internet and it authenticates fine. I can now access the servers but unfortunately it appears the client comes from their 'local' IP address and not the nat address that every other Internet client would see them from. Is it possible to use the nat address (that the firewall will see when establishing the connection) or is it possible to nat the clients to the IP address of the gateway? The reason I ask is that it is causing some routing problems on the servers as they are multi-homed and have static routes which conflict with the clients local IPs Any ideas? Thanks Tim ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ##################################################################################### This e-mail message has been scanned for Viruses and Content and cleared by 3DMail ##################################################################################### ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
