You can use IP Pools where you create an address range (has to be outside of your Internal Network) and assign it.
Works OK, done this a couple of times. -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Cem Akbas Sent: Saturday, June 04, 2005 8:31 AM To: [email protected] Subject: [FW-1] VPN ip pool Using VPN-1 - Securemote, how can i assign IP address to clients. Or is it possible only for SecureClient. Thanks ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ##################################################################################### This e-mail message has been scanned for Viruses and Content and cleared by 3DMail ##################################################################################### ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
