Hi All, I just wondering if anyone tried the SPLAT PRO (R60) multicast PIM-SM feature. Any make it works? Doesn't seems to be working properly for me. I am working on a simple scenario, one router, going into the FW module running SPLAT PRO Source - Router - FW - Destination From the router side, it's configure Router config IP multicasting ip pim rp-address 1.1.1.1 <http://1.1.1.1> Interface ethernet0 ip adress 192.168.1.1 <http://192.168.1.1> 255.255.255.0<http://255.255.255.0> ip pim sparse-mode interface ethernet1 ip address 1.1.1.1 <http://1.1.1.1> 255.255.255.0 <http://255.255.255.0> ip pim sparse-mode FW SPLAT PRO router config (config)# ip pim enable (config)# ip pim rp-address 1.1.1.1 <http://1.1.1.1> group 224.0.0.0/4<http://224.0.0.0/4> (config)# int eth0 (config-if)# ip pim sparse-mode (config-if)# exit (config)# int eth1 (config-if)# ip pim sparse-mode On issueing the command "show ip pim neig" on SPLAT i can see the neighbour 1.1.1.1 <http://1.1.1.1>, but when i issue the "sh ip mroute" no multicast routing table shown. Any feedback? Thanks. Regards, khor
