Where are you looking for the "Shared Secret Option" are yiou talking about in the VPN Community? This is under advanced settings. You can actually configure this in 1 of 2 places. Either under the Community itself or under each gateway under "Traditional Mode Configurations".
Juan -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Tibor Szurok Sent: Wednesday, May 31, 2006 9:09 AM To: [email protected] Subject: [FW-1] VPN shred secret problem Hi I have to setup a internet site to site connection between two checkpoints. My job is to preapre one side. I created in my side an "Interoperable device" for the remote site, configured all the things (what subnets are behind this vpn domain etc..) i addedd a shared secret key between the checkpoint and this "device". After all, i created a meshed vpn community, and addedd these two objects to that. But after this step i can't see anymore the shared secret option, and so i can't change it, until i don't remove the object from the vpn community. I see under the VPN part of the object: "This CP module parcipated the following VPN communities". My questions: -Is this normal? -What should i add the the Interface Ip address for the "Interoperable device"? I have a group of networks what includes a lot of subnets, i added it to the VPN domain "Manulay Defined". But what is the interface address? Is it good, to enter here the same ip as in "general properties"? regards: Tibor Szurok -------------------------------Disclaimer------------------------------- ---- The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= IMPORTANT: The information contained in this electronic message and/or its attachments is intended only for the use of the individual(s) named above and may contain information that is privileged and/or confidential. If you are not the intended recipient, please notify the sender immediately by reply and immediately delete this message and all its attachments without making any copies or distributions thereof. Any review, use, reproduction, disclosure or dissemination of this message or any attachment by an unintended recipient is strictly prohibited and may violate copyrights and/or other laws. Neither the sender, his or her employer nor any of their respective affiliates makes any warranties as to the completeness or accuracy of any of the information contained herein or that this message or any of its attachments is free of viruses. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
