Hi I have an issue with secure client:
Background: We are looking to set up a secure channel and then perform third party authentication inside this tunnel. The cunning plan was to set up client auth using automatic authentication for vpn setup and then allow access to the app on port 80. Problem: I have set this up and it works well - EXCEPT when I packet sniff the traffic (on a hub at the client end) I can see the Checkpoint auth in clear text. I am assuming I have some configuration wrong but are not sure where to look next. Once the auth takes place the rest of the traffic is encrypted. Any help appreciated! Kelvin Brace ##################################################################################### This e-mail message has been scanned for Viruses and Content and cleared by MailMarshal ##################################################################################### **************************************************************************************************************************** CAUTION: This email and any attachments may contain information that is confidential. If you are not the intended recipient, you must not read, copy, distribute, disclose or use this email or any attachments. If you have received this email in error, please notify us and erase this email and any attachments. You must scan this email and any attachments for viruses. DISCLAIMER: Powerco Limited accepts no liability for any loss, damage or other consequences, whether caused by its negligence or not, resulting directly or indirectly from the use of this email or attachments or for any changes made to this email and any attachments after sending by Powerco Limited. The opinions expressed in this email and any attachments are not necessarily those of Powerco Limited. **************************************************************************************************************************** ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
