Hi All How can tell from the cli that which firewall is active. I am running AI r55 on ipso3.8. I ca run tcpdump on the interface to see the traffic going through live firewall but is there any other way to tell which machine Is active and which is standby.. Kind regards Tauseef
************************************************* For addressee only. No legally binding commitments will be created by this e-mail message. Where we intend to create legally binding commitments these will be made through hard copy correspondence or documents. 3i Investments plc Registered office: 16 Palace St London SW1E 5JD Registered no:3975789 Authorised and Regulated by the Financial Services Authority If you are not the intended recipient it may be unlawful for you to read, copy, distribute, disclose or otherwise use the information in this e-mail. If you are not the intended recipient please contact us immediately. E-mail may be susceptible to data corruption, interception and unauthorised amendment, and we do not accept liability for any such corruption, interception or amendment or the consequences thereof. 3i is committed to following policies which protect your privacy and comply with current international data protection laws and regulations in respect of personal data. Further details of these policies can be found at www.3i.com. ************************************************* ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
