Hi,
All of a sudden I cannot get the topology when I configure a new site in
SecureClient r60. If I use a packaged client, I can get connected, but
when I manually created the client, it does not work.I can see in the logs
the FW1_TOPO, and ISAKMP from the client to the firewall, but that is all
that happens. I have the accept vpn controls enabled in the implied
rules.
Does anyone have a idea on what I can check.
Thanks,
Sean
- Did you install other network cards on the host ?
- Check protocol bindings for each interface and make sure that secureclient
is using the correct one.
M.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
