I am running a firewall on HP DL380 and attached to a Proventia G400 and I am having trouble getting the nic's to run at 100/FD. When I hard code them on the Proventia, firewall and switch it causes the nic on the firewall to go to "no link". When I set it to Auto neg on the firewall and Proventia it goes to 100/HD. I can not seem to make this work running a 100/half. I have had the network person set the speed on the switch to Auto neg and when I hard code everything to 100/FD it shows up on the switch as 100/HD. I) I have swapped cables out (both the cross over and straight cable connection) 2) Changed nics from integrated to Intel Pro/1000 Dual Port 3) changed ports on switch 4) went directly from the firewall to the switch (bypassing Proventia) and can run at 100/FD. 5) RMA'd the Proventia box - same problem Spoke with Checkpoint they say its not a problem on the firewall since it can run at 100/FD when connected directly to the switch. ISS so far has no suggestions and has not responded. I was hoping someone else might be running with a Proventia and firewall and could tell me how they made it work while running at 100/FD. Thanks, Annette
================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
