Hi, SIN, thank you for your reply. I am using the DHCP that ships with splat. So is there anything beyond configuring the scopes that needs to be done then? I didn't find anything else other than just configuring the scopes. Based on your response, it sounds like something else needs to be done.
-Lyle -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of sin Sent: Monday, July 09, 2007 11:03 AM To: [email protected] Subject: Re: [FW-1] DHCP Configuration Lyle Dove wrote: > Hello Gurus, > > I have a question about the built-in DHCP service offered in the > Secure Platform offering(R65). I have a remote cluster setup with > ClusterXL in HA mode. I am wanting to utilize the builtin DHCP > service offered in the modules, but I'm not sure how to configure them > so that if one box fails, the other will take over. My assumption is that I setup the exact same DHCP > settings on both boxes, and leave them both enabled. Since one of them is > in Standby mode, it should *NOT* attempt to offer up a DHCP addy. > Once the primary either fails, or is made standby, the previous standby becomes > active, and then the DHCP service from it then becomes active as well. Can > someone confirm this? if you're planing on using an H/A cluster, that only applies for CP, not for dhcp. fyi, isc dhcp ,the one that is being shipped with splat, knows about failover and you need to configure it to act like one. e.g. two servers are up, if one of them fails, the other is aware of the leases from the first and know what to allocate and what not to. good luck, sin ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
