Thanks for the answer, the connection to the portal is ok, but if I want to start an application no ip address is assigned to the client. I think that is the problem.
Regards Tom -----Ursprüngliche Nachricht----- Von: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] Im Auftrag von Matthew Odendaal Gesendet: Freitag, 23. November 2007 09:20 An: [email protected] Betreff: Re: [FW-1] Connectra You have to tell Connectra what address is used for SNX connections. That does not necessarily mean the physical address, but the address the client will connect to (it can be a fully qualified domain name, or an IP address). If you're using NAT, then you have to specify the NAT address instead of the physical address. You can find the setting in the SNX section of Connectra's configuration. Matt -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Robers, Tom Sent: 23 November 2007 10:12 AM To: [email protected] Subject: [FW-1] Connectra Hi, I am having some issues with SSL network extender. I keep getting the message "cannot establish connection to SSL Network Extender gateway. Try to reconnect" when trying to connect over a regular internet link. Through our internal network I can connect with no problems. (Connectra NGX R62CM) Any ideas would be helpful. Thanks all. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
