hi,
do you have the connection between the 2 nokias on the
sync-interface? can you ping the other box?
if the connection 100Mbit/full-duplex?
are the 2 firewall-modules up and running "cpstat fw"?
try to run "cphastart" and check if clusterXL is enabled in "cpconfig".
br
reinhard
At 11:02 28.12.2007, you wrote:
Hello Gurus,
I have a VRRP cluster with two IP740s with IPSO 4.1_build013. I'm
here in the middle of a strange troubleshooting session. Here are the details:
The sync is not working fine. cphaprob state gives the following output.
fw1[admin]# cphaprob state
Cluster Mode: Sync only (IPSO cluster))
Number Unique Address Firewall State (*)
1 10.40.254.165 active
2 (local) 10.40.254.166 down
I tried to unregister and re-register devices from cphaprob list,
but it didn't help. I also have rebooted the problematic cluster member.
fw ctl pstat gives the following message.
Sync:
Version: new
Status:
Unable to send sync packets
Unable to receive sync packets
fwd.elg file is filled up with the following message:
fwsyncn_connected: connection to 10.40.254.165 failed. error=-5
Any ideas anyone?
Wishing You very happy New Year!
-lari-
Lari Luoma
Senior Network Security Specialist
Mainframe Consulting Oy
[EMAIL PROTECTED]
+358-45-6576820
www.mainframe.fi
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
--
Reinhard Stich [EMAIL PROTECTED]
Internet Security AG, 1150 Wien, Johnstrasse 29
Tel: +43 1 3709440 RS784-RIPE Fax: +43 1 3709440-333
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
