Hi, Thanks for your answer. I was totally wrong because in NGX you don't need to set up proxy arp with Nokia.
BR 2008/2/22, pkc_mls <[EMAIL PROTECTED]>: > > kazeka sho a écrit : > > > Hello, > > > > I am currently configuring a Nokia Cluster in VRRP mode active/passive > in > > IPSO 4.2 b042 HF003. > > Everything is OK for the configuration. > > But, I am making Static NAT with Checkpoint NGX R65 for some servers and > I > > would like to know how to do that because I know that I have to make > > Proxy-ARP for the cluster but I did not see the entree for the VMAC I > have > > only the physical MAC of the interface. > > Do I have to add it manualy or is there something wrong on my > configuration? > > > > The virtual arp is shown via an ifconfig on the device itself. > there are also some options to let the fw do automatic arp config, try > to see if it works fine with VRRP. > > > I would like to know if there is another solution instead of using Proxy > ARP > > such as by adding static route because I think the network design would > not > > the same as the one use by my interfaces. So my Nat address would not be > > included in my network interfaces. > > > > > > you can use a nated IP for which the FW doesn't have any interface on > the same nat. > configure your routing so the packets to this fake ip will be redirected > to the FW, then set your Nat. > > > > > Br > > > > ================================================= > To set vacation, Out-Of-Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= > ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
