At 22:22 13.06.2008, Fred Damstra wrote:
On Fri, Jun 13, 2008 at 3:43 PM, David DeSimone <[EMAIL PROTECTED]> wrote:
> You may have to enable Source and Destination NAT columns to appear in
> the logs.
I don't see this option in SmartView Tracker. How do you enable
these columns?
go to the "fw1" selection, there you have the NAT-info.
br
reinhard
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
--
Reinhard Stich [EMAIL PROTECTED]
Internet Security AG, 1150 Wien, Johnstrasse 29
Tel: +43 1 3709440 RS784-RIPE Fax: +43 1 3709440-333
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [EMAIL PROTECTED]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[EMAIL PROTECTED]
=================================================
