I have a similar setup in R65 and the Edge 6.x and working great but our VPN community is a STAR not meshed...and all NAT is disabled within the Edge community. It sounds like a routing issue...(with a possible NAT somewhere).
I would look at getting additional information on the UTM gateway logs by using query properties...before start doing debugs. -----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] On Behalf Of Corrado Motta Sent: Thursday, June 26, 2008 9:37 AM To: [email protected] Subject: Re: [FW-1] VPN vcentral managed between NGX r65 and X-Edge 7.5.51 On Thu, Jun 26, 2008 at 3:49 PM, Previtera, Sal <[EMAIL PROTECTED]> wrote: > Corrado, > How are the Edge(s) defined on the MGMT in the TOPOLOGY section? for the Xedge topology LAN = Internal-> Specific (192.168.x.y/27) WAN external DMZ Undefined > How is the VPN domain defined behind the EDGE(s)? > Manual or ALL IP ADDRESS behind Gateway behind Topology information... the setting is: "ALL IP ADDRESS behind Gateway behind Topology information" > Are you doing any NAT on the Edge side? No nat defined locally. There is a NatRules on the management when I try to connect external IP . > Regards thank Corrado Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
