Hi Ryan, According to the Release Notes for "SecurePlatform 2.6 for NGX R65" (Document from December, 2007), VPN-1 Accelerator Cards II, III, and IV are not supported in this release. They will be supportet with new drivers in the future.
Regards, Matthias -----Ursprüngliche Nachricht----- Von: Mailing list for discussion of Firewall-1 [mailto:[EMAIL PROTECTED] Im Auftrag von Ruiyuan Jiang Gesendet: Montag, 28. Juli 2008 21:22 An: [email protected] Betreff: [FW-1] Hi, all Upgraded SecurePlatform from R60 to R65 (distributed, SPLAT 2.4) without problem. Once patched with HFA_02, reboot, saw a message on the console but not shown on the message log: Configuration NIC failed It looks all the NICs are fine no problem. I ran the command: # vpn accel stat VPN-1: VPN-1 Accelerator Card is not started or not installed There is a Broadcom VPN accelerator card III from CheckPoint installed on the module. Does anyone know whether R65 HFA_02 support the card? I have another R65 (SPLAT 2.6) with VPN accelerator card IV installed and I don't see that message. Thanks. Ryan This message (including any attachments) is intended solely for the specific individual(s) or entity(ies) named above, and may contain legally privileged and confidential information. If you are not the intended recipient, please notify the sender immediately by replying to this message and then delete it. Any disclosure, copying, or distribution of this message, or the taking of any action based on it, by other than the intended recipient, is strictly prohibited. Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] ================================================= Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
