Hey It is not recommended to do it because in this case you will be unable to make cluster. But in case you need it anyway you should enter you management interface (ssh/webui) and add new secondary IP subinterface in network configuration (same place where you r adding VLANS) Alexey
-----Original Message----- From: Mailing list for discussion of Firewall-1 [mailto:[email protected]] On Behalf Of Verweyen, Dirk Sent: Monday, April 12, 2010 10:27 AM To: [email protected] Subject: [FW-1] Bind multiple ip addresses on one Adapter SmartPlatform Hello, is it possible to bind multiple ip addresses on one Adapter on a Smart Platfrom R70 Gateway? How can I do this? Regards, Dirk Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] ================================================= Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
