>>> On 8/5/2010 at 10:16 PM, Suresh Rajagopalan <[email protected]> wrote: > I need to move the external IP of a clusterxl SPLAT (R70.1) pair from a 1g > interface to a 10G one. The IP remains the same and this is *not* the sync > IP. Would the following procedure work without causing downtime? > > 1) run fw unloadlocal on one member
Usually, just run "cphastop" to knock a member out of cluster. You could also simply pull the network cable you're going to swap and the member would go into a "down" state. > 2) move IP to the other interface using sysconfig > 3) Change topology of member in smartcenter > 4) Push policy > 5) repeat #1-4 for 2nd member. > > Would this work? Don't see why it wouldn't. Clusters are great, huh? Also, please don't hijak another thread when posting a new question (you responded to another email so there were "References" headers in your message). Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] ================================================= Scanned by Check Point Total Security Gateway.
