Hi all, another vague stuff for tonight.
I configured a cluster (two utm1 running ngx r65 hfa70) with a dedicated synchro (ie direct cable). the synchro doesn't work (ie cphaprob state shows only one node active) and fwd.elg complains about sync using another IP. (this was defined a while ago as backup sync, but remains somewhere in the config). sometimes a cphastop/cphastart brings the sync back, but any policy installation breaks the cluster sync again. smartcenter was recently upgraded to R71.20. Did anyone already have the same issue ? is there a way to check in the config on the smartcenter that the topology and sync links are correctly defined ? thanks Scanned by Check Point Total Security Gateway. ================================================= To set vacation, Out-Of-Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
