It is really strange because during secureplatform setup all interfaces
are detected. It is true that I have configured only one IP for only one
interface, but I have used this procedure every time that I have
installed a checkpoint gateway, and never happened before, only with
this release.
Many thanks to all.
On 05/26/2011 07:37 AM, Alexey Baltacov wrote:
Sergio:
You may have .1q on this NIC
So Checkpoint assumes that it is "Checkpoint host" only during first
time initialization wizard and not during installation.
Once you configuring 2 or more interfaces (physical or VLANs) - it
will automatically enable the object as "Gateway"
On Thu, May 26, 2011 at 4:49 AM, Sergio Alvarez<[email protected]> wrote:
I have seen this before.
If during the Secure Platform installation there is only one network
interface available, the installation wizard assumes it is a host because a
gateway needs a minimum of 2 available NICs.
I would suggest checking out if Secure Platform has in fact recognized all
NICs on the box.
Regards
--
CL Martinez
carlopmart {at} gmail {d0t} com
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
Scanned by Check Point Total Security Gateway.
