Le 20/03/2012 05:36, pkc mls a écrit :
Hi all,
For the archives.
The solution is to disable the hide behind cluster IP (you have to
disablecluster xl first in the cluster properties, then the option is is
the "3rd party config").
other opion is to add the radius port in the table.def as defined in
secureknowledge.
I try to configure radius auth for my splat admins on an r75.30 cluster.
I systematically receive access-reject errors. (the sameconfig on my
smartcenters that don't run cluster xl works fine,
radius servers are the same).
When I have a look at the radius traces, the radius is sent with the
cluster member IP address, but
uses the virtual IP in the radius client address.
Is this a normal behaviour ?
thanks.
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
Scanned by Check Point Total Security Gateway.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
