Jeff:
If I understand this correctly, it sounds like you need to set up static routes on both the router and the FW-1. If you are using Cisco router, configure this statement: "ip route 64.157.160.0 255.255.255.0 192.168.10.1". On the
FW-1, presumably you are using Solaris 2.x, at the superuser level, add this statement:
"route add -net 64.157.160.0 192.168.10.1"
There are a few notes I want to bring up. First, I presume that your public IP address previously indicated has a
24-bit mask. Second, if your router is connected to the Internet, then I do not think you want to use a non-routable Internet IP address range (192.168.0.0) on the DMZ zone.
Hope this help.
Thuan
-----Original Message-----
From: Jeff Reinhardt [mailto:[EMAIL PROTECTED]]
Sent: Thursday, April 12, 2001 5:40 PM
To: [EMAIL PROTECTED]
Subject: [FW1] Routing Question
I have a Class C address block. I need to be able to
route the traffic and I am having a hard time here.
Router - 64.157.160.254
FW1 - 64.157.160.1 (public)
FW1 - 192.168.10.1 (DMZ)
I need to route all traffic to all other 64.157.160.* IPs through
the DMZ interface.
Can anyone assist me on this?
Jeff
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
