I have the same environment at my house. I was able to use atleast two or
three machines behind my NAT device with SR... I didn't have any problems...
-W
-----Original Message-----
From: David E. Hoobler Jr. [mailto:[EMAIL PROTECTED]]
Sent: Monday, April 23, 2001 3:58 PM
To: FW-1 Mailing List (E-Mail)
Subject: [FW1] VPN products compatible with Firewall-1
I am running Checkpoint Firewall-1 VPN Gateway 250 version 4.1 SP3 at the
office. I would like to set up a VPN from home. I can and have done so
with SecureClient from a single computer with a public IP address.
I have a network at home and would like to access the office network using
multiple computers with private (RFC1918) IP addresses. I understand that
SecureClient can be configured to use a private IP address, but you are
limited to a single machine behind the NAT device. I would like to have
multiple machines behind the NAT device be part of the VPN.
The obvious thing to do is to use a minimum version of Checkpoint at home.
I looked into that and found the cost to be prohibitive. Are there any
other products out there that can remotely interface with Checkpoint's VPN?
My first choice would be a Linux based firewall.
Thanks,
David Hoobler
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
