Check the searchable archive for this mailinglist but if I remember
correctly - on NT this can be caused if you have too many old policies in
the ~\FW\conf directory.
You can delete old policies via the GUI but the corresponding .W and .pf
files have to be removed manually from the directory. I tend to err on the
side of caution by keeping the last few policies as well as the current one.
Also we move the old .W and .pf files to a subdirectory rather than deleting
immediately.
Regards,
Jenny
-----Original Message-----
From: Nils Kolstein [mailto:[EMAIL PROTECTED]]
Sent: 09 May 2001 09:35
To: FW-1 Mailinglist (E-mail)
Subject: [FW1] Errors after saving rulebase
Hi,
Since a few weeks I encounter the following problem when trying to save the
rulebase.. After a while the GUI shows a pop-up with "No reply from server".
It then continues to save the rulebase, which is succesful.. When I close
the GUI, it says "Incorrect reply from server (seq or subject mismatch)"
What is the problem?? The rulebase is correctly saved and new rules are
applied..
Hope someone has a clue..
Nils Kolstein
Internetworking Engineer
ICT Access Services Planet Media Group
E-mail: [EMAIL PROTECTED]
tel: (+31) 033-4540545
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
