Nope. Unless there is a new version i haven't heard of. You could try building a GRE tunnel and encapsulate IPX on that. GRE uses IP - Protocol type 47. So try building a rule with SRC and Destination of tunnel end points and allow IP type 47 in the rulebase.
Cheers,Padhu ----- Original Message ----- From: "Dieter Schutte" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Sunday, March 10, 2002 11:39 AM Subject: [FW-1] IPX with FW1 > Hi All, > > Can FW1 pass / route IPX traffic. What kind of rules and > services should be defined to make this work? I'm planning > to run FW1 (4.1) on NT4, should I enable IPX/SPX on this > machine as well? > > Any help would be appreciated. > > > Kind Regards, > > Dieter > > ================================================= > To set vacation, Out Of Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
