At 14:48 05.04.2002 +0200, you wrote: >Dear all, > >I am now using the CheckPoint Firewall Software VPN-1 & FireWall-1 Version >4.1 and I have to enable RPC (Remote Procedure Call) services among two >machine through the firewall, because I use NIS services. I have found the >right pre-configured service in firewall software, but it seems not to >work because packets of TCP protocol used by RPC are not recognised and >thus dropped by the last rule. Perhaps the firewall is not recognising the >port numbers, that can change without control, depending on the RPC >specific kind of communication. However, the service pre-configured on the >firewall software should work, no matter which port number is used. Is >there a known bug here!? Anyone has experienced something similar? Any >help is very appreciated... >
please check policy -> properties -> services if "enable RPC-control" is enabled. cheers -reinhard -- Reinhard Stich, ASSIST [EMAIL PROTECTED] Internet Security AG, 1190 Wien, Nussdorfer Laende 29-33 Tel: +43 1 370 94 40 RS784-RIPE Fax: +43 1 370 94 40-10 ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
