This is a known problem, when upgrading from FP2 to FP3 It seems that the rulebase gets unrecognizable.
Smartcenter assumes that any unidentified rulebase should be 4.1 or even a 4.0 policy. #fwm load -l41 fw_ver_41_rulebase.W gateway command loads a 4.1 rulebase on the 4.1 gateway with the -l switch. That is the source of -l switch You should try manually upgrading your existing FP2 files to FP3 on SmartCenter with: #fwm up fp2 fp3 Running a pre/post upgrade verifiers is a nice idea. I did not try this since we had to revert back to FP2 upon request ;-) fyi, - yinal ozkan --- Johannes Freygner <[EMAIL PROTECTED]> wrote: > Does anybody has an answer to this: > > During the Mgmt III course my students asked for an upgrade from FP2 to > FP3 on their Windows 2000 stations. After a successful management module > upgrade the policy download to the enforcement module failed on all > student stations with following message:" Target localhosts is not > defined as an NG module, please use the -l flag." > > Thank you in advance > > Johannes Freygner > > Curriculum Management UNIX > Tru64 UNIX, Red Hat Linux and Check Point Training > -------------------------------------------------- > Global Knowledge > "Experts Teaching Experts" > http://www.globalknowledge.at > > Global Knowledge Network GmbH > Gutheil Schoder Gasse 9 > 1101 Wien - Austria > phone: +43(1)665 5655-2216 > fax: +43(1)665 5655-5 > mobile: +43(664)401 2166 > > ================================================= > To set vacation, Out Of Office, or away messages, > send an email to [EMAIL PROTECTED] > in the BODY of the email add: > set fw-1-mailinglist nomail > ================================================= > To unsubscribe from this mailing list, > please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================= > If you have any questions on how to change your > subscription options, email > [EMAIL PROTECTED] > ================================================= ================================================= To set vacation, Out Of Office, or away messages, send an email to [EMAIL PROTECTED] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [EMAIL PROTECTED] =================================================
