Hi Anders,
How do I go about creating a rule in the Fw which allows HTTP for other
ports?
Thanks
Chi
-----Original Message-----
From: Reed Mohn, Anders [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, August 29, 2000 5:57 PM
To: 'Chi Lieu'; FW1_mailinglist (E-mail)
Subject: RE: [FW1] http ports
If you create a rule in your FW that allows
HTTP from the internet, you have only covered port 80.
You have to make sure you have specified access to the other ports.
Or, maybe you have rules before the HTTP-rule that will stop external
clients from entering?
Cheers,
Anders :)
> -----Original Message-----
> From: Chi Lieu [mailto:[EMAIL PROTECTED]]
> Sent: 29. august 2000 08:54
> To: FW1_mailinglist (E-mail)
> Subject: [FW1] http ports
>
>
>
> Hi there,
> I have a web server running IIS sitting in the DMZ.
> The NAT has been setup properly for this IP.
> I am setting multiple web sites using just one IP address
> ,not by creating
> virtual directories but by assigning each site to a unique
> http port say,
> 8081, 8088 etc.
> From the internal LAN, I can get to these sites OK, eg
> http://XXX.XXX.XXX.XXX:8081 or http:/xxx.xxx.xxx.xxx:8088
> However from an external machine, I can't get to these sites.
> Can anyone please advise on what I have missed out in doing?
> Have you had similar experiences and perhaps can share with
> me how to solve
> this?
> Appreciate any replies/ suggestions.
> Thanks
> Chi Lieu
>
>
>
>
>
>
>
> ==============================================================
> ==================
> To unsubscribe from this mailing list, please see the
> instructions at
> http://www.checkpoint.com/services/mailing.html
> ==============================================================
> ==================
>
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
