I had this same problem, I had to to a combination fwstop / new cert /
fwstart and after a couple of iterations of either doing it with the fw
management console stopped / and then trying it with the fw management
console started, and then restarting it - the certs just showed up. -
but you are doing it correctly when it says that it created them.
Hope this helps!
CHuck
-----Original Message-----
From: Mark van Kerkwyk [mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 07, 2000 5:14 AM
To: Firewall-1 Maillist
Subject: [FW1] Hybrid IKE Securemote problem
Hi,
I'm having problems getting Hybrid IKE Securemote setup, I have
followed the CP document on it.
Running 4.1 and I have the following eval license.
10.10.10.10 30Sep2000 cpsuite-eval-des-v41 cprs:4.1:rs5
cpsuite-eval-des-v41 cprs:4.1:rs5 CK-EE0136198FC4
I have created the internalca (using fw internalca create -dn
"O=FRED,C=US") and certified the firewall object (fw internalca certify
-o
FW-MOF "O=FRED,C=US") , both appear to work successfully, but when I go
into the workstation object, there are no certs in the list, no is there
an
option to select Hybrid in the IKE workstation properties
Any ideas ?? Could there be a licensing issue, is a ca license required
??
Thanks
Mark
========================================================================
========
To unsubscribe from this mailing list, please see the instructions
at
http://www.checkpoint.com/services/mailing.html
========================================================================
========
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
