I think that the Aaron Turner's reply to this was best. Do a VPN tunnel
between the two domains. With all these ports open on the FW you have
reduced your security by a large factor.
Karl Shepard
Bobosh, Inc
-----Original Message-----
From: Michael Hernandez [mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 14, 2000 2:01 PM
To: '[EMAIL PROTECTED]';
[EMAIL PROTECTED]
Subject: RE: [FW1] How to enable ports in Firewall-1
Create a Rule to allow src (your NT domains) dst (your other nt domains) and
for service add the following;
NBT <---- group opens 137,138,139)
tcp-high-ports <----opens ports 1024 thru 65535)
(your going to have to create a new service for port 135 either tcp/udp)
Hope that Helped
Michael
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 14, 2000 4:20 PM
To: [EMAIL PROTECTED]
Subject: [FW1] How to enable ports in Firewall-1
I have 2 NT domains in my WAN, I would like to create trust relationship
across
a Firewall-1. How can I configure Firewall-1 to open ports 135, 137, 138,
139
and all ports above 1024.
Thanks in advance
Rales
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
