Michael,
Basic network connectivity is a must and you have
proven it works. It sounds as if one fw is configured
properly(or is wide open) and the other is in need of
a rulebase review.
Verify that the firewall(s) have the correct rulebase
entries. Verify your NAT entries and most definitly
your logs. If your still having trouble, forward along
some setup and network info.
Robert
- -
Robert P. MacDonald, Network Engineer
Team Lead, e-Business Infrastructure
G o r d o n F o o d S e r v i c e
Voice: +1.616.261.7987 email: [EMAIL PROTECTED]
>>> "Michael Mills" <[EMAIL PROTECTED]> 12/17/00 11:32:21 AM >>>
>
>Ok,
>
>Here is my setup
>
>2 Locations with two different networks
>
>Location A IP = 10.10.0.0 Subnet Mask 255.255.0.0
>Location B IP = 10.15.0.0 Subnet Mask 255.255.0.0
>
>Problem:
>
>On my NT FW1 Box when the security policy is not loaded everything routes
>fine I can ping the other network, they can ping through. As soon as I load
>a security policy one of the networks will not route anymore.
>
>My Setup is as follows
>
>FW1 box:
>
>EXT_Interface = x.x.20.0 Default Gateway = Next internet hop
>INT_Interface - 10.10.20.1 No Default Gateway set, SUBNET MASK = 255.255.0.0
>
>Routing table looks like this:
>
>0.0.0.0 0.0.0.0 x.x.20.0
>10.20.0.0 255.255.0.0 10.10.20.1
>10.15.0.0 255.255.0.0 10.10.20.14 <----IP Address of internal router, This
>is also a manual route addition...
>
>I can not figure this one out any help would be appreciated...
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
