Hi,

>- After modifying the file in both files, what must I do in order to
>activate the new tests? I have read about "sbcontrol restart" in both
>firewalls... is it right? what is the behaviour? is there some service
hit?

Yes, you need to restart StoneBeat any time you make changes to the
configuration files in SBHOME/etc, including checklist. The "sbcontrol
restart" command will perform this action. In order to restart, tell the
primary to go offline, issue "sbcontrol restart", then switch it back
online. The secondary will take over for a few minutes while you do this,
preserving the connections. Then you can do the secondary when it's offline
again.

>- I don't understand very much the "timeout" field. I suppose the
necessary
>time to switch over in case of problems is "interval" * "retry count".
>Therefore, what is the meaning of "timeout"?

The "timeout" field is used whenever you specify an external program (as
opposed to the StoneBeat built-in tests), and it specifies the amount of
time in milliseconds that StoneBeat should wait for a response (either an
error or success result) before abandoning that test run and going to the
next test. It doesn't apply to built-in tests, so for those a placeholder
of "1" is often used.

The "interval" is how often (in seconds) that StoneBeat should run the
test. It cannot be set to anything less than 3 or 4 seconds, as otherwise
the product would spend all of its time testing and not actually doing the
HA.

----------------------------------------------------------------
Mark Boltz                                       Stonesoft, Inc.
Network Security Specialist           115 Perimeter Center Place
[EMAIL PROTECTED]              South Terraces, Suite 1000
Tel: +1 770 668 1125                           Atlanta, GA 30346
Cel: +1 404 386 8500                                         USA
Fax: +1 770 668 1131                    http://www.stonesoft.com

New support numbers!
Toll free:    866-435-7324
Other areas:  678-259-3400




================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================

Reply via email to