Check out the 43 ways to to a putkey at Phoneboy:
http://www.phoneboy.com/fw1/faq/0038.html
Cheers!
-john
-----Original Message-----
From: Velasquez Venegas Jaime Omar [mailto:[EMAIL PROTECTED]]
Sent: Friday, January 26, 2001 12:42 PM
To: FW1-MailingList (E-mail)
Subject: [FW1] Authentication for command fetch failed
Trying to install FW-1 on a Distributed Mode , we have this *typical*
scenario:
[M.Module] ------[FW-1] --------[Internet]
Suppose M.Module and one of FW-1 Interfaces are on the trusted zone.
M.Module is doing NAT to a valid ip address too.
On M.Module , after Managament Module installation we did:
Remote Modules: [Interface on Trusted Zone of FW-1]
fw putkey [Interface on Trusted Zone of FW-1]
On FW-1 Module , after Firewall Module installation we did:
fw putkey [Interface on trusted zone of M.Module]
However , when we start fw-1 service on FW-1 , we get this error:
Authentication for command fetch failed
Fetching security policy from [Interface on trusted zone of M.Module]
failed!
How can i fix this?
Also , are those fw putkey ok?
and yes both workstations can *see* each other
Jaime O.
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
