Make sure you allow the VRRP communication (port 112) between firewall
modules on the policy installed.
Rick McMaster
Sr. Network Security Engineer
ePlus Technology
http://www.eplus.com
Nasdaq: PLUS
-----Original Message-----
From: MikeCC [mailto:[EMAIL PROTECTED]]
Sent: Monday, January 29, 2001 10:43 AM
To: [EMAIL PROTECTED]
Subject: [FW1] FW's constantly changing state
Hello,
I am running two Nokia 650's with FW 4.1 running VRRP.
The issue I am having is that every couple of minutes both firewalls change
state, from installed to disconnected and back from disconnected to
installed.
When I look at the VRRP status, both firewalls think they are the
master. The firewalls are connected for a Cisco 6509 switch, but I have
since put them on a simple hub and still see the same behavior.
Any suggestions?
MikeCC
http://atrek.org/mikecc
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
