If you configured remote logging through Voyager you more than likely
configured remote logging of syslog or SNMP messages and not FW-1 logging.
Look in /var/log/syslog (or wherever your logs for a given alert and
severity) are on the machine you listed as the remote box.
If you want to configure your FW enforcement points to log FW-1 log messages
to a nonlocal machine MC, you will list the hostname/address in
$FWDIR/conf/masters or (I believe) any non-local MC or FW enforcement point
in $FWDIR/conf/loggers.
Chris
-----Original Message-----
From: Ekblad, Eric M
To: '[EMAIL PROTECTED]'
Sent: 8/2/01 2:48 PM
Subject: [FW1] CP 4.1; logging messages through another Nokia.
Dear all:
<<FW1>> <<FW2>> Management server
We are trying to send logging messages to the management server. The
Management server shows both firewalls as green checks and shows that
FW1 is
sending logging messages.
In Voyager, we are logging to remote host, management server. No NAT is
being used in this set-up.
1. Is there any other way to check where FW1 is sending messages to?
2. Is there a way on 4.1 to check the = to the masters file (4.0)?
Eric
========================================================================
========
To unsubscribe from this mailing list, please see the instructions
at
http://www.checkpoint.com/services/mailing.html
========================================================================
========
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
