I recently got a Toshiba 60GB and installed it in my Pismo
Drive set to Master?
Cables seated firmly?
So I figured I needed to start up with my original Pismo (9.0.4) install or restore CDROM(s). However, when I try to boot up with either of those, I get as far as the startup screen and it freezes
Try with shift key held down.
Can you boot fully with the new HD disconnected? (trying to verify it's a bus/device hang, not something else)
external FireWire/USB case with my Pismo's old 10GB drive
If it's not a master/slave issue, and disconnecting the HD lets your PB boot... Put the original HD back in. Put the new drive in the external bridge case. Boot. Then plug in the external and see if you can use / format the drive.
HTH, - Dan.
-- G-Books is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Check our web site for refurbished PowerBooks | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
G-Books list info: <http://lowendmac.com/lists/g-books.html> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-books%40mail.maclaunch.com/>
---------------------------------------------------------------
The Think Different Store
http://www.ThinkDifferentStore.com ---------------------------------------------------------------
