I must disagree with this advice. "Very tightly" will probably see a few daughtercards cracked. There is no 'snap' in replacing the heatsink, like there is when replacing the daughtercard, as you snap the connector.


As I see it, the best way to reinstall the heat sink is;
Firstly, clean both faces (CPU and heatsink) using naptha (lighter fluid)
or alcohol.
Put a matchhead size blob of heat transfer compound on the centre of the CPU.

Put the heatsink in the correct location, and start all 3 screws (2 on sink, 1 on other end).


Then, pressing firmly on the heatsink, - directly above the CPU - , tighten each screw a little bit each time, until they are firm. Do not overtighten; a stripped thread would be the least problem you could get!

        Good luck.

        On Jan 17, 2005, at 5:16 PM, G-Books wrote:

On my Pismo, the fan was almost never running. I also remember once when I
did replace something in it that I didn't firmly put the heat sink over the
processor. Over a few minutes, the fan was starting to run, although it
never did before. That told me that something was wrong inside. The heat
sink needs to kinda "snap" around the processor very tightly for the heat
dissipation to work...



-- G-Books is sponsored by <http://lowendmac.com/> and...

Small Dog Electronics    http://www.smalldog.com  | Refurbished Drives |
-- Check our web site for refurbished PowerBooks  |  & CDRWs on Sale!  |

     Support Low End Mac <http://lowendmac.com/lists/support.html>

G-Books list info:      <http://lowendmac.com/lists/g-books.html>
 --> AOL users, remove "mailto:";
Send list messages to:  <mailto:G-Books@mail.maclaunch.com>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive: <http://www.mail-archive.com/g-books%40mail.maclaunch.com/>



---------------------------------------------------------------
iPod Accessories for Less
at 1-800-iPOD.COM
Fast Delivery, Low Price, Good Deal
www.1800ipod.com
---------------------------------------------------------------



Reply via email to