Hi, Anybody here that has some experience with Atto PCIe SCSI-cards in a G5 quad running Tiger? I've just put an ATTO ExpressPCI UL5D in my quad connected via an internal HD68 to 50pin and 50pin to external HD50 connector. The quad didn't start at first, apparently it tried to start up from my old Microtek scanner
I can see the ATTO card in System profile now as two pci-bridges in slot 3 where the card is seated and two Atto Express PCI UL5D cards in slot 7x4 plus under Parallel SCSI I see two SCSI Parallel Domain devices, 0 and 1. The ATTO Configuration Tool didn't install properly and whenever I had the external HD50 connector engaged the quad wouldn't start, no matter if the scanner was on or off. So then I uninstalled the ATTO Config. Tool and everything works but no cigar, no scanner is seen by VueScan. I bought the Atto card especially to keep using my Microtek Scanmaker III. What can I possibly try to get my setup working again? The scanner worked perfectly with my G4 MDD connected to an Adaptec PCI card. RIP. TIA for your replies, best regards, Jörg -- -- You received this message because you are a member of G-Group, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs. The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml To post to this group, send email to g3-5-list@googlegroups.com For more options, visit this group at http://groups.google.com/group/g3-5-list --- You received this message because you are subscribed to the Google Groups "G-Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to g3-5-list+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/d/optout.
