Brian,

This looks a lot like some of the stuff I have played with with my "plumber's 
Bunsen burner".  One note of caution.  As you turn up your combustion air, 
watch your gasifier suction level.  You may find it going up quite a bit, 
enough to skew your results.  You may inadvertently be creating a jet ejector 
suction pump like the Dasifier or the GEK flare.

Stephen
-----Original Message-----
From: Brian D Paasch <[email protected]>
To: Discussion of biomass pyrolysis and gasification 
<[email protected]>
Sent: Sun, Oct 17, 2010 9:20 pm
Subject: [Gasification] more on flare design/performance



Hi all,


Since the Board has recently done another round of discussion on flare design, 
I thought I'd toss in a video on the subject. Last time we did a test run of 
our unit, we did a step series of increasing air injection into the base of the 
flare assembly. There are two things wrong with this test/demonstration. 1) I 
did not include a zero air into the base of the flare. The lowest tested/shown 
was passive air flow through the holes in the base of the flare. In hindsight, 
I should have dug up some tape and completely closed off the air vents in the 
bottom of the flare for a zero air datapoint. My bad.


2) We did not have (and we have no plans to add) a flow meter to our forced air 
line to the flare. So the various levels of forced are are reported in "psi", 
which is pretty much meaningless apart from the qualitative "more" or "less".


Here is the video:  
http://www.youtube.com/watch?v=wAxSvYNODI4&videos=HMEX-nkxkc8


-brian


= 

_______________________________________________
asification mailing list
to Send a Message to the list, use the email address
[email protected]
to UNSUBSCRIBE or Change your List Settings use the web page
ttp://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org
for more Gasifiers,  News and Information see our web site:
ttp://gasifiers.bioenergylists.org/

_______________________________________________
Gasification mailing list

to Send a Message to the list, use the email address
[email protected]

to UNSUBSCRIBE or Change your List Settings use the web page
http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org

for more Gasifiers,  News and Information see our web site:
http://gasifiers.bioenergylists.org/

Reply via email to