Hi, If you have a formula for cutting bio oil for use in boiler burners and a burner approved for 200 psi steam boilers, please let me know.
Phillip On Thu, Sep 15, 2011 at 12:46 PM, <[email protected]> wrote: > ** > In a message dated 9/15/2011 12:36:04 P.M. Eastern Daylight Time, > [email protected] writes: > > Hello all, > > Long time reader, first time poster. > > I am planning on building a small gasifier to run an IC engine for > electricity and heat. > > About 3/4 of my available energy is in the form of chipped forest waste and > the balance is waste oil. > > > > If possible I would like to add the waste oil to a downdraft gasifier for > drying and cracking. > > Has this been tried and were the results favorable or would I be wasting my > time. > > My thought was to control oil flow by utilizing a vacuum pump from the > engine. > > > > Obviously I could use the waste oil in a separate burner, but that would > seem to be unnecessary, perhaps not. > > Any thoughts would be greatly appreciated. > > > > edge > > Mark, > Filter the oil,mix it with diesel, and burn it in a diesel motor. > Also, soak the oil into the wood chips and burn them for heat. > > Dan Dimiduk > > _______________________________________________ > Gasification mailing list > > to Send a Message to the list, use the email address > [email protected] > > to UNSUBSCRIBE or Change your List Settings use the web page > > http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org > > for more Gasifiers, News and Information see our web site: > http://gasifiers.bioenergylists.org/ > >
_______________________________________________ Gasification mailing list to Send a Message to the list, use the email address [email protected] to UNSUBSCRIBE or Change your List Settings use the web page http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org for more Gasifiers, News and Information see our web site: http://gasifiers.bioenergylists.org/
