Corey Hudson wrote:
>> I'm trying to connect from the external interface
>> with SNMP to a host on the internal network. But I
>> can't get it to work.
>>
>> Can anyone tell me how I should do? How do I write
>> the filter? Should I use IP pass through?
>>
>> External ip: www.xxx.yyy.zzz ("Internet")
>> Internal ip: 192.168.10.2 (NAT)
>> Protocol: UDP/SNMP (I'm running mrtg on the external host)
>>
>> Thanks in advance.
>
> Jonas,
>
> Your best bet is to set up an in bound tunnel using port 25 and then
> provide the Remote Access filter from 0.0.0.0 to the external ip address of
> your firewall. There is an example of this in the manual under appendix C,
> example 1. It is showing 4 tunnels (web, ftp, DNS and e-mail). In your
> case you would only need the one tunnel. However, if your DNS is behind
> the firewall your most likely going to need the tunnel and filter set up,
> as well.
What do you mean? Port 25?
My scenario:
External Internal
-------------------------------------
Linux -> FW -> Cisco
(mrtg) GnatBox Switch
mrtg uses snmp to poll for statistics from the switch.
Would appreciate a detailed instruction on what and where I
should config.
Thanx.
/jonas
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
To subscribe to the digest version first unsubscribe, then
e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
Archive of the last 1000 messages:
http://www.mail-archive.com/[email protected]
