Hello,
I have been trying to get Gnatbox Light version 3.4.0 to run for a
little while tonight. I have Gnatbox Light version 3.3.4 running just fine.
So I build a new floppy with 3.4.0 and seems to not be able to pick up the
default route from DHCP request. Did some in 3.4.0 change to require me to
hard code the default route?
Also, for some reason, version 3.4.0 cause the warning temperature
alarm to go off within 2 to 3 minutes of the PC booting. Note, the CPU is a
Celeron 333 (the one with 128KB of cache). The warning temperature alarm is
set at 50 degree Celsius but I try increasing it to 53 degrees Celsius -
made no differences. All PC cooling fans are running there is good air flow.
Note, I can run version 3.3.4 without the warning temp alarm going
off nearly for every or until the next major power outage which every comes
first. ;) The warning temperature alarm never goes off.
I have try making several different floppy disk just in case a bad
floppy was my problem but that made no differences.
I staying with version 3.3.4 until I can figure out why this is
happening. Any one see any of this or heard of this? Any ideas?
Thanks for the help,
Andrew "Dyslextic" Batson
------------------------------------------------------
To unsubscribe: [EMAIL PROTECTED]
For additional commands: [EMAIL PROTECTED]
Archive: http://www.mail-archive.com/[EMAIL PROTECTED]
