https://gcc.gnu.org/bugzilla/show_bug.cgi?id=56659
--- Comment #10 from Tobias Burnus <burnus at gcc dot gnu.org> ---
(In reply to Manuel López-Ibáñez from comment #9)
> (In reply to Tobias Burnus from comment #8)
> > f951: Warning: Include directory ‘foo/bar/’: Permission denied
> > <built-in>: Error: foo/bar: Permission denied
> > (The <built-in>
>
> Are you sure the Error is produced *after* entering the file (by entering I
> mean pushing the file into the include stack and thus updating the
> line-map).
I was too brief. It occurs between the two. The full version is:
If everything is not on the file stack 'f951' is printed, then the '<build-in>'
stuff happens, from "gfc_cpp_init":
cpp_change_file (cpp_in, LC_RENAME, _("<built-in>"));
....
cpp_change_file (cpp_in, LC_RENAME, _("<command-line>"));
(similar: c-family/c-opts.c: c_finish_options)
This could be undone (to print 'f951') by calling cpp_change_file with to_file
= NULL – but I am sure it won't have undesired side effect.
And only after the file has been successfully opened, linemap_add is called.
Thus, the '<built-in>' shows up between gfc_cpp_init() and linemap_add.
Or code wise, in gfc_init:
if (!gfc_cpp_enabled ())
{
linemap_add (line_table, LC_ENTER, false, gfc_source_file, 1);
linemap_add (line_table, LC_RENAME, false, "<built-in>", 0);
}
else
gfc_cpp_init_0 ();
...
if (gfc_cpp_enabled ())
gfc_cpp_init ();
...
gfc_new_file ();
with gfc_new_file:
if (gfc_cpp_enabled ())
{
gfc_cpp_preprocess (gfc_source_file);
if (!gfc_cpp_preprocess_only ())
load_file (gfc_cpp_temporary_file (), gfc_source_file, true);
}
else
load_file (gfc_source_file, NULL, true);
and in load_file:
input = gfc_open_file (realfilename);
if (input == NULL)
gfc_fatal_error ("Cannot open file %qs", filename);
...
f = get_file (filename, (initial && !preprocessed_p) ? LC_RENAME : LC_ENTER);
the latter then calls
linemap_add (line_table, reason, false, f->filename, 1);
> In either case, this points to some mess in the line-map stack.
Suggestions how to improve the code above?