Phil,
You didn't mention whether this was "incidental" silkscreen like a
"ElementLine" that overlapped the pad or something related to the pad
itself.. A previous version of pcb would in some cases generate
silkscreen rectangles in the gerber output on some surface mount pads.
I was never able to figure out what combination(s) of features would
cause this to happen, but it does appear to be fixed in the most recent
revision of pcb. (You can and should look pretty carefully at your
gerber output to make sure it is correct.)
Joe
ptay wrote:
DJ,
About a year ago I got some boards back with silkscreen printed over
some pads. Since, I've manually kept the silkscreen off the pads.
... Does MinMaskGap work on silk too?
Phil
DJ Delorie wrote:
F.1.41 MinMaskGap
MinMaskGap(delta)
MinMaskGap(Selected, delta)
Ensures the mask is a minimum distance from pins and pads. Checks all
specified pins and/or pads, and increases the mask if needed to ensure
a minimum distance between the pin or pad edge and the mask edge.
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user