On Sun, 26 Nov 2006 19:32:36 -0500 Dan McMahill <[EMAIL PROTECTED]> graced us with this prophetic message:
> DJ Delorie wrote: > > One-day project, so I can play with an R8C mcu: > > > > http://www.delorie.com/pcb/r8c-1b-adapter/ > > > > Anyone know how to clean off "no clean" flux? I just want to pretty > > up the board, and make it less sticky. > > I'd try either water or the "usual" flux cleaner. FWIW, I don't trust > "no clean" flux. I want it off. I don't have any scientific data, but > have seen some anecdotal evidence that leaving it on may cause some > issues (undesired conduction paths showing up over time). > > -Dan > > > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user Hi, DON'T use water. This actually re-activates the flux which is not what is desired, and also leaves a white residue making the joint look uglier than if it's not cleaned up. Rick. _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user