One of my vendors has a tool which uses a vacumn on a robotic arm to grab the back of a device. Then they move the device over a container of very sticky flux and lower it down until the bottoms of the balls just bearly touch the flux.
The tool then moves the device over the fab and they position an optical splitter between the fab and the bottom of the device. This optical splitter allows them to move and rotate the arm until the devices balls and the fabs pads are preceisly aligned. The optical splitter is then removed and the device lowered onto the fab. The sticky flux serves a secondary purpose as a temporary glue holding the device until it is run through the oven. I am told that the adhieseve strength of the flux is enough to hold the component in place even if you were to throw the fab like a frisbe. Steve M. On Tue, 2007-01-30 at 19:59 -0500, DJ Delorie wrote: > > Are you using one of the syringes that is pressure driven with a > > foot pedal valve? Or are you using a sharp toothpick? > > I'm using a hand-pressure syringe from stencilsunlimited.com. I press > just enough to get a concave bit of paste peeking out of the nozzle, > then tap it on the pads. > > If I try to squeeze out a drop, it gets too much and too messy. > > > _______________________________________________ > geda-user mailing list > geda-user@moria.seul.org > http://www.seul.org/cgi-bin/mailman/listinfo/geda-user _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user