On Fri, Feb 23, 2007 at 12:09:02PM -0500, Steve Morss wrote: > Here's something that looks like it will work. I haven't used it, so > you should make sure it looks right to you.
Thanks very much. There are a few issues with it, in case anyone else wants to use it. The more detailed doc is: http://www.molex.com/pdm_docs/sd/716612068_sd.pdf 1) The pin numbering is wrong. The pin numbering is based on the fingers in the connector running from 1..n/2 across the top and n/2+1..n on the bottom, so the pin marked "18" is actually "2" and the pin marked "2" is actually "3" and so on. 2) The mounting pins are plastic, so the holes should be unplated, I would think. I don't know if there's a standard for this in pcb elements. 3) I'm going to add an outline to the silk layer so I don't do something silly like put a resistor under the edge or recess it too far from the edge of the board! Thanks again to Steve for putting me on the right track. -- Ben Jackson AD7GD <[EMAIL PROTECTED]> http://www.ben.com/ _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user