Ben Jackson wrote:
On Wed, Mar 21, 2007 at 04:00:28PM -0400, Ryan Seal wrote:
problem and need to move each trace to the opposite side of the board.
I did this once. It's easy, just edit the .pcb in a text editor,
find the block with the lines, and move them around. So you'll
see something like:
Layer(4 "component")
(
Line[239000 53000 230900 53000 2500 2000 ""]
Line[259000 38000 254000 43000 2500 2000 ""]
...
)
Just move the Line bits (or change the Layer "statement").
It worked. I changed my layer names via emacs and then swapped my
component-side and solder-side labels in pcb. I suppose I could have
done this through the pcb interface (as DJ Delorie suggested) but wasn't
quite sure and I laid down almost 500 traces before catching my obvious
mistake - so I was a little hesitant.
Thanks again,
Ryan
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user