On 7/24/07, DJ Delorie <[EMAIL PROTECTED]> wrote:
> http://www-nw.uni-regensburg.de/~.grr06742.back.physik.uni-regensburg.de/PCB/GPS_BUG.PCB I reproduced it. > If I try to draw a copper rectangle on GND-comp it either doesn't > draw one at all or scrambles it in the lower left corner. Smaller > areas work fine though. When zooming it sometimes appears again but > in the printout it's never right. I get the messages : I've reported this before, but Harry hasn't offered a fix for it. He's the only one who really knows how the clipper works. With sufficient zooming/scrolling, you can make pcb segfault too.
I just ran into this same issue when I was displaying a plane layer where a polygon covers most of the board. When there are a lot of perforations in the polygon due to vias and pins I get a segfault after "sufficient" scrolling. Joe T _______________________________________________
geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
_______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user