On Mon, Aug 06, 2007 at 12:20:49AM -0400, DJ Delorie wrote: > > > It's caused by some non-clearing traces (probably accidental) drawn > > on the GND layer just to the "south" of U300. > > If you mean the 0.04 mil lines, those are intentional. I was trying > to use them to cut a hole in the ground plane under the crystal > circuit. They clear polys, but have a negative keepaway. The end > result is supposed to be a clean hole in the copper, but it kept > crashing.
Even if I fatten them up, you don't seem to have completed an outline in that area. I don't think making a few-unit wide clear is going to work very well. The LinePoly code is going to make a polygon with several degenerate segments. You can just make a 'normal' width line of at least a few mil and set the clearance to 0 to get the effect you want. -- Ben Jackson AD7GD <[EMAIL PROTECTED]> http://www.ben.com/ _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user